Stainless Steel

---

These two new MAP sensor adapters from Holley EFI allow you to quickly add a stainless steel MAP sensor to your existing installation. Holley part #558-466 adapts harnesses with a (MPFI) Weatherpack 3-pin connector to the 3-pin Delphi GT connector, commonly found on aftermarket stainless steel MAP sensors, such as the Holley 5-BAR MAP sensor, part #554-108. Holley part # 558-467 adapts harnesses with a Delphi M/P 150 3-pin connector, commonly found on LS engine harnesses, to the 3-pin Delphi GT connector

• Genuine OEM (original equipment manufacturer) Connectors
• Techflex F6 loomed harness provides protection from engine bay dirt and grime, while matching your Holley EFI harness for a clean installation
• Plug and play pre-termination allows you to quickly convert any installation to an aftermarket MAP sensor

---

Information:

Holley Performance Emission Code 3: This part is legal for sale and use on Uncontrolled (Non-Emissions Controlled) Vehicles and Racing Use Only Vehicles. The following vehicles are considered Uncontrolled (Non-Emissions Controlled) Vehicles: 1965 and older U.S. manufactured California Certified vehicles/1967 and older U.S. manufactured Federally Certified vehicles/1967 and older Foreign manufactured vehicle. The following vehicles are considered Racing Use Only Vehicles: Racing Use Only Vehicles are vehicles that are used exclusively for competition and that are not registered and that may never be used on the street. WARNING: It is against the law to install this part on an Emissions Controlled Vehicle. The following vehicles are considered Emissions Controlled Vehicles: 1966 and newer U.S. manufactured California Certified vehicles/1968 and newer U.S. manufactured Federally Certified vehicles/1968 and newer Foreign manufactured vehicle

---

Application Summary:

Year	Make/Model
Genuine	OEM (original equipment manufacturer) Connectors Holley EFI (MAP) Manifold Air Pressure Harness Adapters . Holley part # 558-467 adapts harnesses with a Delphi M/P 150 3-pin connector
commonly	found on LS engine harnesses
to	the 3-pin Delphi GT connector